V4.0 ==== - Focus on RDM E1.37-7 endpoints - Filtering settings made on the splitter are now pushed to the RDM controller - Changes to A/B routing made on the splitter are now pushed to the RDM controller - Added endpoint identify (= identify per output port) Fixes: - Fixed the problem where an RDM endpoint device could be disconnected from a port, but never re-recognized again if you'd replug it. - Fixed bug where the endpoint device list counter could go below zero To upgrade the unit, best is to set the following parameters in LumiNet Monitor, in the preference menu>RDM>Timing: * Outlet traffic interval:100ms * Keep alive: 2s It is strongly advised to factory reset the unit after upgrading the firmware from a version previous to V4.