2015/02/18 :: version 4.1.8 * Added Ethernet-DMX8/Truss MkII target * Fix: No warning when ArtNet output universe in same sub-switch or net-switch * Fix: RDM response framing error 2014/02/12 :: version 4.1.6 * Added firmware info to front-end display * RDM interweaving option per outlet * Improve RDM discovery * RDM controller IP can be locked * Trigger source IP can be locked * Added ArtCommand messaging for UDP triggering * Improved boot time with 20 seconds * Fix: outlet status page (cosmetic) * Fix: load sACN input priority correctly from profiles * Fix: correct IP binding index in ArtPollReply * Fix: front-end display contrast no saved correctly * Fix: Custom merge ip locking issue when more outlets on same universe and different IP * Fix: Apply previous password setting after firmware upgrade * Fix: profile recall no network from front end menu * Fix: incorrect port index for port 5 to 8 for ArtRdm traffic 2013/02/15 :: version 4.1.5 * front-end display menu * bug fix for RDM input * ArtNet III support * Reroute function * ArtDmx sequence numbering * cosmetic css fixes for web interface 2011/12/20 :: version 4.1.3 * New gateway field added in the Ip settings to allow the node to run in a routed network. 2011/10/05 :: Version 4.1.2 * improvements to the serial drivers (lower interrupts so more idle time) * Fixed problem with IGMP that prevented the join requests to be correctly being sent. * Fixed the routing of the multicast packets for the higher range of addresses. * Fixed problem with luminet not correctly taking over the new IP in case of an IP change. * Fixed problem with fixture takeover in luminet - 4.1.1 (not released) * support for dinMX4 target * fixed bug with sACN input priority 2011/06/02 :: Version 4.1.0 * Introduce RDM support (NEW) * Introduce sACN protocol support (NEW) * Improve system performance. Timings are stricter and system load decreased so more universes can be handled. * Bug fix: Flicker could occur with very short break and mab timings on DMX input. 2010/06/04 :: Version 4.0.10 * Bug fix: impossible to use custom soft-patch on IP merged outputs when using a 6 channels DMX desk * Bug fix : Impossible to release the password set on Web interface * Improved processing of DMX inputs result in minimal delay * New default DMX settings for future compliance with RDM protocol * New Break time minimum value for RDM compliance * New MAB time minimum value for RDM compliance * New Web interface shortcuts for easy outlet configuration (direction, universe number, mode) * Web interface now supports Spanish and German languages